ELANTAS Electrical Insulation

Finishing Varnishes

Finishing varnishes are applied on surfaces in order to protect them against humidity, chemicals and workplace contamination. 

These can be applied by dipping, brushing and spraying. Prior to any of these application methods, it is important to ensure the substrate is clean and dry.

Typical ELANTAS finishing varnishes:

Product Viscosity Temperature IndexTypical Cure ScheduleDescription
Elmotherm® F 93 A+B10 - 20 s
ISO Cup 6 mm 23°C
18024 h / 23°C or
2 h / 100°C
Two component, solvented, finishing varnish, room temperature curing, very good film forming, excellent resistance to chemicals, available as colourless or oxide red. For dip, brush or spray application.
Elmotherm® FS19037 - 43 s
ISO Cup 6 mm
23°C
15524 h / 23°C or
2 h / 100°C
Single component, alkyd resin based, solvented finishing varnish, very good film forming, good resistance to moisture and chemicals, available colourless or red oxide. For dip, brush or spray application.
Elmotherm® 009-0008100 - 125 s
B4 Cup
21°C
1801 h / 23°C or
30 min / 80°C
Single component, UL recognised, alkyd resin based, solvented finishing varnish, fast air drying, available in a range of colours, colourless, golden, red oxide, black, grey and white. For dip, brush or spray application.
Elmotherm® VA 16025 35 s
Ford 4 Cup
25°C
15524 h / 25°C or
2 h / 80°C
Single component, UL recognised, alkyd resin based, solvented finishing varnish, fast air drying, available colourless or red oxide. For dip, brush or spray application.
Aquanel®  H 2001300 – 500 mPa.s
25°C
1803 h / 23°CSingle component, UL recognised, water based, epoxy modified varnish, low VOC. Good bond strength, moisture and chemical resistance. Suitable for motors, coils and transformers. Red pigmented version also available, Aquanel H2002. For dip and brush application.